Technicolor DPC3848VE Velocidad : Technicolor DPC3848VE Características
I have the Technicolor DPC3848VE DOCSIS 3.0 from Fibertel with 100 MB. I recently acquired a WIFI card (TP Link Archer T6E AC1300 Dual Band) and the problem I have is that running the speedtest gives me a drop of just 10 mb in the 5ghz band and does not reach 2mb in the 2.4 band. With network cable it goes to the top.
I have w10 with all the updates and the latest driver for the motherboard installed from the tp link page. Someone did the same? Any scholar on the subject who can give me a hand??…
Question
I have the modem configured to connect to the devices via Mac plus a password, the problem I have is that they hack my network so I have this type of security, even my brother entered me with an app called WPS… Is there a way to make the network hidden or not visible or to configure the part of the modem that says alert notifications by email… Cool, if another unregistered Mac enters me, it will notify me and I can block it…?????
Answer
With the Dells there is something that installs itself called SmartByte that makes the speeds do not exceed 10mbps, it happened to me. With uninstall it started working fine
I had fibertel with technicolor modem DPC3848VE DOCSIS 3.0. I decided to switch to Telecentro and they changed my wiring and brought me a new modem. My house has 2 floors and the Wi-Fi reaches very weak upstairs, so I always had an old router configured as a bridge. It occurred to me that perhaps I could use the fibertel modem in bridge mode since it is surely more powerful than the junk I have, and I began to read on the internet. I plugged it into my pc via ethernet, entered the config and when I changed the mode to “only bridge” it was loading and never went from there. A sign appeared that it was going to restart at the ip 192.168.100.1 but it never happened.
I grabbed and decided to reset the modem to try changing the mode again and that’s where the problem began. When I plug it back in via ethernet to my pc, when I enter the config it’s like it’s loaded badly. In addition, everything appears at 0 and it does not let me log in with the default username and password “admin” and “cisco” nor with my previous password.
I don’t know what to do. I hope someone can help me either to get to log in again or to configure it as a bridge if possible.
Thank you all so much and I look forward to your help! Greetings!!
Because the 2.4 standard is 54mbps. You must have a router and a plate with 3 antennas to have 150 mbps or more. It is not guaranteed, it also depends on the spectrum.
